Laminate Flooring. Wednesday , July 25th , 2018 - 12:19:02 PM
WD-40. While most folks are aware of the lubricating properties of WD-40, not many realize that it is also a terrific household cleaner. To remove scuffs from your high gloss laminate, apply a bit of WD-40 to a soft cloth and lightly scrub until the marks disappear. Be sure to wipe up the lubricant residue with a wet rag to prevent any potential slip-and-fall accidents.
Toothpaste. If you don't have any baking soda at home, there's no need to run to the store. You can often get the same effect by using plain toothpaste to touch up your floor.
Now that you've started laying your laminate flooring you will undoubtedly find that you need to cut some of your boards when you reach the far side, or the top or bottom side of the room. The best tool for the job is a laminate cutter, which is purpose-built to give a quick, easy, clean cut to your laminate, without creating the mess of using a hacksaw. As you proceed through the laying, make use of beater blocks, and pulling bars along with a hammer, to encourage the boards to sit tightly and form a good lock together. A beating block is a buffer between your board and your hammer, to prevent damage to the board, and a pulling bar is a useful tool when you reach a wall, and there is no room to hammer a board in place; instead you insert the pulling bar into the gap between your laminate flooring and the wall, and then hammer the vertical lip of the bar to encourage the board in place.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does www.kokopellimusic.us claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.